Before the Automatic Slitting Line For Steel is put into operation, check whether the working positions are properly adjusted. If lubrication is required, the lubricating grease should be added in advance. Check if the tool is sharp. After the automatic cutting machine is normal, you can run the empty car first, check whether there is any abnormality, and input the processing order into the computer to check the order in advance; after the automatic cutting machine is put into work, the equipment should be adjusted according to the production situation.
Good working condition, ensure that the 8 Mm Slitting Line machine is moderately indented, cut and burr-free, and the trimming position on both sides is suitable. Ensure that the cross-cutting machine has smooth paper feeding and accurate cutting length. For vertical and horizontal cutting machines that are connected to production management, it is also necessary to monitor the operation of the machine at the same time. Beware of paper jamming and defective products. After the work is finished, clean the equipment on time. Dust and paper scraps, check the knives and sharpening wheels into the Tissot Tissot watch http://m.wbiao.cn/tissot-watches/, check the oil in the water and the water in the gas storage tank, check the running parts There are no abnormalities. Then, according to the instructions, cut off the power supply and maintain the computer operating system.

1. Ensure that the voltage, current and hydraulic equivalents are correct and stable before starting the machine.

 

2. Before the equipment is ready for operation, all personnel must notify the departure device to ensure personal safety before starting operation.

 

3. When running, do not touch the running film roll or roll core with your hand to avoid personal injury caused by hand entrapment.

 

4. During the operation, it is forbidden to scratch or cut each roller core with a knife or a hard object.