Here is Hr Slitting Lines China Exporter talking about The Development Of Automatic Slitting Machine. 

If you have any idea about Hr Slitting Lines, welcome to contact us and discuss.

The emission power of the slitter is a comprehensive concept. In the cutting process, the stable tension system of the automatic slitting machine is the main target to ensure the quality of the product. The magnetic powder clutch and brake are a special active actuator. The automatic slitting machine is filled in the mission gap or The film is cut into moments, and the magnetizing current can be modified to change the magnetic state of the magnetic powder, thereby adjusting the transmitted torque. It can be used for stepless speed regulation from zero initial to synchronous speed. It is suitable for high-speed section fine adjustment and medium and small power speed regulation system.
The automatic slitting machine controls the tension between the unwinding, pulling, slitting and winding so that the slitting data is always in a fluctuating state during the slitting process.

Assuming that the tension control is stable, the automatic slitting machine can prevent the original data from being deformed and drifted during the process of speeding up and slowing down the machine. The meeting will create the sum of the troubles of the next process and the tension of the reel. Automatic slitting machine Most of the previous slitting machines use magnetic powder clutch to control the tension, but the magnetic powder clutch speed cannot be high. The automatic slitting machine is easy to form the high-speed conflict of magnetic powder during operation, and the automatic slitting machine is now mostly used. The sagittal variable frequency motor is used to control the tension system of the slitting machine. The active detection of the pendulum roller is adopted. The human machine is used for low temperature, and the automatic slitting machine shortens its life. When it is severe, it will be stuck and the machine will be blocked.

With the development of technology, servo drive skills, and other components. It is the cutting of raw materials into a number of independent units, the mission principle is to fix the raw materials on the discharge, a magnetic powder tension controller at one end of the discharge shaft to stabilize the raw materials The required tension is then pulled through a pair of rubber rollers to pull the raw materials. The fully automatic slitting machine is cut into several strips by the blade and then guided by the guide rollers to the A and B winding reels to stop the winding products.

At the same time, 3 Mm Slitting Line can be offered for you.  Looking forward to receiving your inquiry.